Stromtank
Stromtank Source Component Power Generators
S-2500 Quantum
The next generation Stromtank S2500 Quantum MKII adds upgraded battery management circuitry, latest generation lithium ion batteries, as well as digital distortion suppression technology eliminating digital and backwards interference from other audio components, combined with a 12V trigger and network control, making the Stromtank models easier to integrate into any installation application.
S-1000 Independent Power Source
The consequent way to natural sound
Today‘s AC power lines are affected by countless active electricity consumers, which leads to a high load and considerable pollution of the electricity. When AC noise trickles into the critical components of an audio system, low signals are faded out and performance is affected. This low-level content is critical as it conveys the critical over-tones and environmental conditions in audio and depth and clarity in videos. Under these circumstances nobody exhausts the real full potential of their high-end audio systems and is looking for a clean, undisturbed grid power to achieve the next level of music quality.
Total Isolation
One of the most important aspects to consider if you want to hear the excellent quality of your audio-components is the purity and stability of the grid signal.
Only the Stromtank power generators offer you the unique opportunity to provide your system with stable energy, completely disconnected from the electrical grid. This complete network separation works for hours and the main feature of each Stromtank is a powerful generator combined with a high capacity battery. Stromtank uses a special type of LFP battery – the LiFe-PO4. These batteries are intrinsically safe, environmentally friendly, very cycle- resistant and lightweight. The excellent load capacity and a long service life speak for the future of this technology.
The perfect addition for your audio-setup
When you switch to the disconnected mode, the Stromtank provides all the perfect clean power for several hours and you system is completely disconnected from the grid. No more fluctuations. No more noise. Just perfect clean power for you system to perform at its best. The Stromtank recharges automatically from the mains when the battery state-of-charge exceeds a critical minimum.
STROMTANK – The power foundation that lifts up your system!
S-2500 Quantum MK II Independent Power Source
Upgrade your listening pleasure.
In order to achieve the next level of music quality with their hi-fi systems, audiophiles often look for a clean, undisturbed grid power. The purity and stability of the grid signal is one of the most critical factors in recognising the excellent quality of one’s audio components.
The grid is influenced by everyday equipment including computers and appliances. Everything is connected to the same dirty grid that is polluted by DC Voltages, high noise levels and various frequencies. All interferences affect audio-quality and even the best power conditioners are not able to completely eliminate the disturbances.
Stromtank has been designed to separate your hifi- system completely from the grid to supply clean, undisturbed power to achieve the next level of music quality with your hifi-system.
Don’t wait until midnight to get the best sound!
The Stromtank is a high-power battery pack with integrated pure-sine wave converter power supply – totally disconnects your audio system from the grid.
The perfect addition for your audio-setup
The next generation Stromtank S2500 Quantum MKII adds upgraded battery management circuitry, latest generation lithium ion batteries, as well as digital distortion suppression technology to all outlets. This new digital distortion suppression technology eliminates digital and backwards interference from other audio components, to provide an even quieter, cleaner background.
With Stromtank S 2500 you can enjoy many hours of listening to music before it connects uninterrupted and automatically with the grid to recharge.
During the recharging process you can listen without any interruption. Even when the Stromtank is connected to the grid, the current pulses are not taken directly from the grid - they are absorbed by the battery. In the AC- connected mode the Stromtank creates a stable AC-supply (amplitude and frequency) and has less interaction between the grid and your audio or video setup.
When the battery state-of-charge reaches a critical minimum, the Stromtank will automatically recharge itself from the mains. Every Stromtank model generates its own AC voltage signal from batteries that are recharged under the control of multiple microprocessors. Once charged, the device is disconnected by an internal power relay.
With the Stromtank, the quality of premium home theatre equipment is both visually and sonically enhanced.
Handcrafted to the highest standards in Berlin, Germany.
S-1000
Input AC Parameters ON-grid | ||
Input Voltage – factory set | : | 100 - 120 Vac / 230 - 240 Vac |
Input Frequency range – factory set | : | 45 to 65 Hz |
Input Current Adjusted – factory set | : | 10 Aac |
Transfer Time | : | < 15 ms, on grid to off grid |
Output AC Parameters OFF-grid | ||
Output Voltage – Factory Settings | : | 100-130Vac / 200-245Vac (pure sine wave) |
Output Frequency | : | 50 Hz / 60 Hz +/- 0.05% (crystal controlled) |
Harmonic Distortion | : | < 2% |
Continues Power @ 25°C | : | 450 VA |
Power 30min. @ 25°C | : | 700 VA |
Peak Power 3sec. @ 25°C | : | 1.800 VA |
Ø battery operating time / average load 400VA (Cos φ=1) | : | 2.5 hours |
Maximum Load | : | up to short circuit |
Maximum Asymmetric Load | : | up to p cont. |
Load Detection (standby) | : | 2.5 W |
Cos φ | : | 0.1 – 1 |
Maximum Efficiency | : | 93% (dc/ac conversion mode) |
Consumption Stand-by / on | : | 1.5 W / 8W |
Overload + short-circuit protection | : | automatic disconnecting with 3 restart attempts |
Overheat Protection | : | warning before shut-down with automatic restart |
Operating Temperature | : | 10 °C – 45°C |
Relative Humidity | : | 0 - 85% non-condensing |
Acoustic Level | : | < 29 dB |
Battery power Unit | ||
Battery Type | : | LFP - Lithium Iron Phosphate (LiFePO4) |
Nominal Battery Voltage | : | 24 Vdc |
Nominal Capacity | : | 40 Ah |
Charge Current – Factory Setting | : | - |
Working Temperature | : | - |
BMS – Battery Management System | : | 5 Adc |
Working Temperature | : | Output AC Parameters OFF-grid |
BMS – Battery Management System | : | Active Balancing |
BMC – Battery Main Controller | : | Main Controller and Monitor Processor |
CMC – Cell Management Controller | : | Sensing Temperature, Current and Voltage |
Terminal Area | ||
AC Output Receptacles | : | 4x... Hubbell duplex, Hospital Spec. Grade |
OR | : | 4x... Furutech High perf. Schuko sockets |
AC Output Fuse | : | thermal – magnetic circuit break |
AC Input Connection | : | ICE 320 - C14 (fuse 16/10AT) |
Interface | : | 3 service ports |
Power Switch | : | on/off (“on” = green LED) |
Safety key switch for Shipping | : | key switch “Release/Lock” all functions |
Additional Features | ||
Finish Standard | : | Silver Anodized* |
Dimensions | : | 48 x 22 x 47 cm (WxHxD) |
Weight | : | 41 Kg |
Options | : | * Metallic-black and meteorit front-finish available at additional cost. |
: | Custom Finish upon request |
S-2500 Quatum
Input AC Parameters ON-grid | ||
Input Voltage – factory set | : | 100 - 120 Vac / 230 - 240 Vac |
Input Frequency range – factory set | : | 45 to 65 Hz |
Input Current Adjusted – factory set | : | 10 Aac |
Transfer Time | : | < 15 ms, on grid to off grid |
Output AC Parameters OFF-grid | ||
Output Voltage – Factory Settings | : | 100-130Vac / 200-245Vac (pure sine wave) |
Output Frequency | : | 50 Hz / 60 Hz +/- 0.05% (crystal controlled) |
Harmonic Distortion | : | < 2% |
Continues Power @25°C | : | 650 VA |
Power 30min. @ 25°C | : | 1.100 VA |
Peak Power 3sec. @ 25°C | : | 2.600 VA |
Ø battery operating time / average load 400VA (Cos φ=1) | : | 4 hours |
Maximum Load | : | up to short circuit |
Maximum Asymmetric Load | : | up to p cont. |
Load Detection (standby) | : | 2.5 W |
Cos φ | : | 0.1 – 1 |
Maximum Efficiency | : | 93% (dc/ac conversion mode) |
Consumption Stand-by / on | : | 1.5 W / 8W |
Overload + short-circuit protection | : | automatic disconnecting with 3 restart attempts |
Overheat Protection | : | warning before shut-down with automatic restart |
Operating Temperature | : | 10 °C – 45°C |
Relative Humidity | : | 0 - 85% non-condensing |
Acoustic Level | : | < 29 dB |
Battery power Unit | ||
Battery Type | : | LFP - Lithium Iron Phosphate (LiFePO4) |
Nominal Battery Voltage | : | 48 Vdc |
Nominal Capacity | : | 40 Ah |
Charge Current – Factory Setting | : | - |
Working Temperature | : | - |
BMS – Battery Management System | : | 8 Adc |
Working Temperature | : | Output AC Parameters OFF-grid |
BMS – Battery Management System | : | Active Balancing |
BMC – Battery Main Controller | : | Main Controller and Monitor Processor |
CMC – Cell Management Controller | : | Sensing Temperature, Current and Voltage |
Terminal Area | ||
AC Output Receptacles | : | 3x... Hubbell duplex, Hospital Spec. Grade |
OR | : | 4x... Furutech High perf. Schuko sockets |
AC Output Fuse | : | thermal – magnetic circuit break |
AC Input Connection | : | ICE 320 - C14 (fuse 16/10AT) |
Interface | : | 3 service ports |
Power Switch | : | on/off (“on” = green LED) |
Safety key switch for Shipping | : | key switch “Release/Lock” all functions |
Additional Features | ||
Finish Standard | : | Silver / Black Anodized* |
Dimensions | : | 48 x 31 x 45 cm (WxHxD) |
Weight | : | 57 Kg |
Remote Control | : | Optional |
Options | : | * Metallic-black and meteorit front-finish available at additional cost. |
: | Custom Finish upon request |